I've got some 1x fired brass that ranges in length. The measurement from the shortest to the longest case is .005". Would you trim or leave it?
How close are these measurements to the "trim to length" for your cartridge ?I've got some 1x fired brass that ranges in length. The measurement from the shortest to the longest case is .005". Would you trim or leave it?
In that case, "IF" ..........I were going to crimp , with such as a Lee Factory Crimp Die, I would want them all the same length.6.5 PRC cartridge. Length ranges are well within case dimensions
Yep.....In that case, "IF" ..........I were going to crimp , with such as a Lee Factory Crimp Die, I would want them all the same length.