Looking to reuse a barrel
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Can I get a 28 Nosler barrel reworked to 7mm PRC?
- Thread starter LISBON
- Start date
Help Support Long Range Hunting Forum
Thanks, the rework the stock, right?
How many rounds on it with the 28? Your stock won't need any work the barrel would be moving back so you will have a little more gap between it and the stock.
About 300 rounds
It cam off my Gunwerks rifle.
Could I get it fitted to a TIKKA action?
Could I get it fitted to a TIKKA action?
If I am cutting it back, am I not getting it reamed for new life at the same time?
Thanks for your advice in advance. I am a newbie here.
Thanks for your advice in advance. I am a newbie here.
7.62 Gunner
Well-Known Member
Why are you ditching the 28 Nos?
You have at least 2/3 of the barrel life left.
You'll have to cut the entire chambered portion of the barrel away because the 7 prc is skinnier than a nos, I doubt you'll even have enough shank left to rechamber.
If you're set on switching over then get a new barrel
Hugnot
Well-Known Member
I periodically do stuff like that. Upon ordering a new barrel I specify a contour having a long shank. Then upon realizing that 7-10 % extra case capacity is not providing any realistic advantage I have the existing treads cut off or more & have the barrel rechambered. Bullets & primers are pricy and good certain results are valuable. As for the stock, scrape down any existing bedding in shank area and replace with new bedding - JB steel weld works good. My limit for shank length is not under 1.75 inches from receiver end. If over 700 rounds or so depending on caliber go for a new barrel. Feels real good to go back to a round that has available cheap brass.
this is true. I think you'll be stuck getting a new barrel.
The cost that you will have, doing what your thinking, I would bet would be more than a new barrel. Sale the 28 nos barrel to help with the cost of a new barrel. Now your bolt and box will need reworked?????
If you buy a Blank it still requires smith work. Bolt and mag will jive.The cost that you will have, doing what your thinking, I would bet would be more than a new barrel. Sale the 28 nos barrel to help with the cost of a new barrel. Now your bolt and box will need reworked?????
lancetkenyon
Well-Known Member
That is a very optimistic number. I have seen them last between 400-900 rounds when run like a 28 Nosler should be run.
If you want 7RM speeds to prolong barrel life...run a 7RM.
