Brass Prep Tracking Sheet

[Rockfish Dave]

Not sure how many of you are like me; forget where you left off on the brass prep process on that plastic container of brass in the corner. I've been using these for the past 5 years or so and helps allot!

This is what I do, but you can easily change up as per your process. I print and cut out the sheets and they stay with the brass until loaded.

 

[GLTaylor]

Very handy. Thanks.
My sheet is not nearly as nice.

 

[Rockfish Dave]

Very handy. Thanks.
My sheet is not nearly as nice.

The odd thing is I anneal twice. Once before sizing, gives me much less run out and consistent seating "feel". The second and final is to ensure the brass is fully restored to "new" elasticity for dead on seating tension. Again, it's my way, but there are a million ways to skin a cat.

Unfortunately it would not allow me to upload the excel sheet...

 

[marchboom]

Looks like my checklist. Definitely leaves no doubt what stage you are in with brass prep.

The only thing I add to the list is the brand/type of primer installed.

 

[Rockfish Dave]

Here I think I cracked the nut. By compressing this into a zip file I think the excel spreadsheet will post.

Hope this is helpful.