Brass Prep Tracking Sheet

Rockfish Dave

Well-Known Member
Joined
Dec 21, 2008
Messages
359
Not sure how many of you are like me; forget where you left off on the brass prep process on that plastic container of brass in the corner. I've been using these for the past 5 years or so and helps allot!

This is what I do, but you can easily change up as per your process. I print and cut out the sheets and they stay with the brass until loaded.
 

Attachments

  • Cleaning & Prep tracking sheets.xlsx.pdf
    58.9 KB · Views: 83

Rockfish Dave

Well-Known Member
Joined
Dec 21, 2008
Messages
359
Very handy. Thanks.
My sheet is not nearly as nice.
The odd thing is I anneal twice. Once before sizing, gives me much less run out and consistent seating "feel". The second and final is to ensure the brass is fully restored to "new" elasticity for dead on seating tension. Again, it's my way, but there are a million ways to skin a cat.

Unfortunately it would not allow me to upload the excel sheet...
 

marchboom

Well-Known Member
Joined
Feb 12, 2008
Messages
92
Location
North Idaho
Looks like my checklist. Definitely leaves no doubt what stage you are in with brass prep.

The only thing I add to the list is the brand/type of primer installed.
 

Rockfish Dave

Well-Known Member
Joined
Dec 21, 2008
Messages
359
Here I think I cracked the nut. By compressing this into a zip file I think the excel spreadsheet will post.

Hope this is helpful.
 

Attachments

  • Cleaning & Prep tracking sheets.zip
    10.7 KB · Views: 29

Recent Posts

Top