Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Brass length question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="243winxb" data-source="post: 2037462" data-attributes="member: 97793"><p>2.620" to 2.600" is OK. When brass reaches maximum of 2.620" then trim back the standard .010" or less. Its possible to maintain a 2.620" trim length. This requires fl sizing & trimming every loading. Each brass must be checked for length & chamfer and deburr also.</p><p></p><p>There is a "safety zone" built into most chambers of around .010" If a longer then maximum trim length shell is chambered, the case mouth will not get crimped into the chamber. There are tools & ways to measure chamber length.</p></blockquote><p></p>
[QUOTE="243winxb, post: 2037462, member: 97793"] 2.620" to 2.600" is OK. When brass reaches maximum of 2.620" then trim back the standard .010" or less. Its possible to maintain a 2.620" trim length. This requires fl sizing & trimming every loading. Each brass must be checked for length & chamfer and deburr also. There is a "safety zone" built into most chambers of around .010" If a longer then maximum trim length shell is chambered, the case mouth will not get crimped into the chamber. There are tools & ways to measure chamber length. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Brass length question
Top