Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding 20MOA Rail
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mxracer532" data-source="post: 766479" data-attributes="member: 63551"><p>So I have searched and read and watched Youtube video's and still have a ?.</p><p>I prefit the EGW rail to my Vanguard and what I noticed is a small gap in rear corner with screws in the front. So I checked with screws in the back and there was a little bit more of a gap in the front than the back. So do I tighten the back screws and bed only the front and hope I dont screw up the 20moa base? Or bed both front and rear and only slightly tighten the 2 inside screws? Thanks guys.</p></blockquote><p></p>
[QUOTE="Mxracer532, post: 766479, member: 63551"] So I have searched and read and watched Youtube video's and still have a ?. I prefit the EGW rail to my Vanguard and what I noticed is a small gap in rear corner with screws in the front. So I checked with screws in the back and there was a little bit more of a gap in the front than the back. So do I tighten the back screws and bed only the front and hope I dont screw up the 20moa base? Or bed both front and rear and only slightly tighten the 2 inside screws? Thanks guys. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding 20MOA Rail
Top