Anyone use a LAW stock??

They are what was left of High Tech Specialties. Nice stocks though they take quite a bit of work to finish properly. Mark Bansner is doing stocks again but I'm not sure if he offers a Weatherby inlet. I can get you measurements from an Extreme Sheep Hunter tomorrow but that is the only one I have experience with. They are as slim as they get.
 
What measurements would you like? I have a short action LAW rifle, can grab some measurements off it.

I like it much better than the b&c sporter stocks, they have that awkward thick wrist. But it still is fairly wide along the bottom metal.
 
Sorry took me a day, darned working for a living..

In front of the trigger guard is 1.84"
Front action screw 1.75"

The bottom is rounded right where the bottom metal sits, but is a bit more squared off infront of that. Hopefully it shows in the picture
 

Attachments

  • 14164136-E545-4FAE-BA39-69A3769692FD.jpeg
    14164136-E545-4FAE-BA39-69A3769692FD.jpeg
    749.9 KB · Views: 97
Warning! This thread is more than 4 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top