Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Any recommedations on a Neck Turning Tool
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Sneaky Apasum" data-source="post: 1070071" data-attributes="member: 85336"><p>A bushing die before or after you turn the necks? I ask because I am just getting into this and don't know. I was reading that the case needs to be full length resized with a non bushing die before turning to get the entire neck sized right. I had planned on doing that, then fireforming again (brass is once fired) and using a bushing die to get my final load. If I could skip a step and save an unnecessary firing on my brass, that would be great.</p></blockquote><p></p>
[QUOTE="Sneaky Apasum, post: 1070071, member: 85336"] A bushing die before or after you turn the necks? I ask because I am just getting into this and don't know. I was reading that the case needs to be full length resized with a non bushing die before turning to get the entire neck sized right. I had planned on doing that, then fireforming again (brass is once fired) and using a bushing die to get my final load. If I could skip a step and save an unnecessary firing on my brass, that would be great. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Any recommedations on a Neck Turning Tool
Top