Any load data for 124 Hammer Hunters in a 6.5x284 using H1000 0r H4350

[gkempf]

Want to try some124s but am struggling finding load data for the H4350 and H1000. Any assistance would be greatly appreciated.

 

[RockyMtnMT]

I think you will be better off with the 4350. H1000 is likely too slow to get to pressure. Start at 47g and work up from there.

 

[gkempf]

I think you will be better off with the 4350. H1000 is likely too slow to get to pressure. Start at 47g and work up from there.

Thank you Sir.

 

[26Reload]

Following......very curious in your results..
I am planning to use RL23....

 

[Ernie]

Want to try some124s but am struggling finding load data for the H4350 and H1000. Any assistance would be greatly appreciated.

I have used H-4350 with 130's and 140's for years with great success.
I would start with 48.0 grains and work my way up

 

[WYO300RUM]

I

Following......very curious in your results..
I am planning to use RL23....

Following......very curious in your results..
I am planning to use RL23....

I've had good accuracy and velocity with RL23 and 124 Hammer. RL23 Hard to find though. I'm down to 1 pound.
I forgot. I haven't used in my 6.5x284 yet but have in 6.5 PRC.

 

[Shane Lindsey]

Following......very curious in your results..
I am planning to use RL23....

6.5x284 Norma

124 Hammer Hunter RL23
Lapua cases
51.5gr -3005
52.5 -3092***
53.5 -3149
54 -3182
54.5 -3240

 

[26Reload]

Thx shane...Shane....
52.5 is my 26" cf rifle...120fps faster
52.3 is my 23" packing rifle...140fps faster.....
...'that's faster than my current 142LRABS'

 

[Jared06]

IMR 7828 might be worth a try

 

[dougduey]

I used H4831 two barrels ago with great results. Settled on a lower node around 3140 fps since it was so accurate and better than the higher node (which was over 3200 fps). Waiting on the new barrel to get chambered and installed.
From the results of others, I'm going to use N560. Should be able to get above 3400 fps with it.