ADG 338 edge brass meaurments.

Discussion in 'Reloading' started by Rhovee, May 26, 2018.


Help Support Long Range Hunting by donating:


  1. Rhovee

    Rhovee Well-Known Member

    Messages:
    540
    Joined:
    Jun 29, 2017
    Starting to put together a 338 edge. Going to use ADG 338 edge brass and Whidden dies and 300 grain elite hunters. Wondering if someone can give me a loaded round OD so i can buy the bushing.
     
  2. can1010

    can1010 Well-Known Member

    Messages:
    569
    Joined:
    Feb 27, 2012
    only have the 338 rum brass not the edge. .014 neck , .367 loaded with 300 otm. hope that helps
     
  3. Swamplord

    Swamplord Well-Known Member

    Messages:
    1,226
    Joined:
    May 2, 2004
    IMG_6563.JPG Load development is ongoing with ADG 338 Edge brass, Cutting Edge 265 gr Lazer and 260 gr Maximus bullets, neck diameter dims in loaded rounds comes in at .367", loaded with .003" bullet tension
     
  4. Rhovee

    Rhovee Well-Known Member

    Messages:
    540
    Joined:
    Jun 29, 2017
    Awesome. I bought a .364 bushing so I should be close to you.
     
  5. Swamplord

    Swamplord Well-Known Member

    Messages:
    1,226
    Joined:
    May 2, 2004
    didn't take a pic but I just seated Berger 300 gr OTM and a 300 gr Hunting bullets into prepped cases and both came in at .367"
     
  6. Swamplord

    Swamplord Well-Known Member

    Messages:
    1,226
    Joined:
    May 2, 2004
    Here ya go

    IMG_6568.JPG