Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Absolute Hammer load data
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JTH" data-source="post: 2219132" data-attributes="member: 59647"><p>I've had the same issue with the hammers sticking in the seating die. Someone on this site (can't recall who) recommended the following: put the hammer bullet in the chuck of your drill. Wrap a cleaning patch around the bullet that has been saturated in JB bore bright. Hold the stem in a vice or pliers and use the coated bullet to thoroughly polish the inside of the stem with the drill. After doing this procedure, I haven't had a problem with the bullets pulling back out.</p></blockquote><p></p>
[QUOTE="JTH, post: 2219132, member: 59647"] I’ve had the same issue with the hammers sticking in the seating die. Someone on this site (can’t recall who) recommended the following: put the hammer bullet in the chuck of your drill. Wrap a cleaning patch around the bullet that has been saturated in JB bore bright. Hold the stem in a vice or pliers and use the coated bullet to thoroughly polish the inside of the stem with the drill. After doing this procedure, I haven’t had a problem with the bullets pulling back out. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Absolute Hammer load data
Top