Absolute Hammer load data
- Thread starter RockyMtnMT
- Start date
Help Support Long Range Hunting Forum
dougduey
Well-Known Member
STOP!!! You're killing me!!
I'm sorry it can't be Mud because I'm sure he still hasn't sold that truck yet so he aint got no funds to buy no Hammers C'mon Back
dougduey
Well-Known Member
Hand Skills
Well-Known Member
Yes, 4831 is too slow. H4350 may leave some velocity on the table but should give you nearly perfect case fill.
In my last couple of emails with Steve, he has suggested using Hodgdons website and picking a powder in the same bullet weight (or close to it) as the AH. Start at the max charge and go up until you find pressure. I like to cross reference with Nosler to see what case fill is at and see if I have room for more powder.
From looking at both load data sites, W760 and IMR7828 may be good choices. ButterBean is going to give me hell about suggesting 7828 since we have a long standing inside joke about it.
That's good advice from Steve.
I like checking Nosler data for casefill also, but I found it didn't quite line up with Hammers for me. Seems the Hammers protrude deeper into the case than a typical Nosler, so the cases seem to run out of capacity a little quicker (assuming SAAMI OACL).
I think 7828 is too bulky, but you might be onto something with W760/H414 though. Haven't tested it myself yet.
dougduey
Well-Known Member
Since W760 is a ball powder, it should work really well. Probably could go with 7828 Short Cut to get more in there.
My COAL's are typically longer than SAAMI spec, so I tend to get around this some. Mag length is my general limiting factor.
Muddyboots
Well-Known Member
Don't overlook Hodgdon Hybrid 100V as another shortcut powder that loads well, fills well, good velocity. Big plus is seems to be available. Hair slower than H4350 and hair faster than IMR4831.
H414/W760 is good stuff, Temp sensitive but easily predictable
RogerPA
Well-Known Member
Worked today on .257 Roberts and the 90 grain Absolute Hammer. Temp:30F,
Powder H335, Primer Fed210, COAL 2.88
Barrel 22" (Kimber) 1/10 (Book max with 90 gr. Sie HPBT 43 gr. H335 @ 3100 FPS.
42 gr. 3112 FPS
43 gr. 3224 FPS
44 gr. 3291 FPS
45 gr. 3373 FPS
46 gr. 3456 FPS
46.5 gr. 3516 FPS (slight ejector mark)
47.0 gr. 3475 FPS (heavy ejector mark/bolt lift) Still room left in the case, but reached pressure at 46.5/47. Looks like 46 gr. is about the place for this rifle/power/bullet combination. All weights grouped into one neat little group, with only a bit of horizontal stringing. This rifle has never been a real "shooter", but at less than 7 lbs. with sling & scope included, it's fun to carry. It appears this .257 Roberts will really gain a lot of punch with the Absolute Hammers. At 3450 FPS the 90 grain AH generates 2400 EFP, while the existing 117 gr. load I've been using (@2875 FPS) generates only 2100 EFP.
Powder H335, Primer Fed210, COAL 2.88
Barrel 22" (Kimber) 1/10 (Book max with 90 gr. Sie HPBT 43 gr. H335 @ 3100 FPS.
42 gr. 3112 FPS
43 gr. 3224 FPS
44 gr. 3291 FPS
45 gr. 3373 FPS
46 gr. 3456 FPS
46.5 gr. 3516 FPS (slight ejector mark)
47.0 gr. 3475 FPS (heavy ejector mark/bolt lift) Still room left in the case, but reached pressure at 46.5/47. Looks like 46 gr. is about the place for this rifle/power/bullet combination. All weights grouped into one neat little group, with only a bit of horizontal stringing. This rifle has never been a real "shooter", but at less than 7 lbs. with sling & scope included, it's fun to carry. It appears this .257 Roberts will really gain a lot of punch with the Absolute Hammers. At 3450 FPS the 90 grain AH generates 2400 EFP, while the existing 117 gr. load I've been using (@2875 FPS) generates only 2100 EFP.
.270 win
139 Absolute Hammer
COAL 3.345
Bartlein 24.5 in barrel
twist 1-9
Temp 30 F
Powder H4350
Federal 210 match primer
Nosler brass
52-53 labradar wasn't reading [first time using]
53.5 gr - 2929 fps
54 - 2967
54.5 - 3038
55 - 3032
55.5 - 3073
56 - 3096
56.5 - 3127
57 - 3167
57.5 - didn't read
58 - 3225
58.5 - 3232 faint ejector mark
59 - 3257 slightly brighter ejector mark
59.5 - 3294 BRIGHT ejector mark.
Will back off a hair and look at 57-58 range some more.
All were in a 3 inch group at 200 yards.
Excited to say the least.
Labradar is awesome.
Thanks everyone for guidance!!
139 Absolute Hammer
COAL 3.345
Bartlein 24.5 in barrel
twist 1-9
Temp 30 F
Powder H4350
Federal 210 match primer
Nosler brass
52-53 labradar wasn't reading [first time using]
53.5 gr - 2929 fps
54 - 2967
54.5 - 3038
55 - 3032
55.5 - 3073
56 - 3096
56.5 - 3127
57 - 3167
57.5 - didn't read
58 - 3225
58.5 - 3232 faint ejector mark
59 - 3257 slightly brighter ejector mark
59.5 - 3294 BRIGHT ejector mark.
Will back off a hair and look at 57-58 range some more.
All were in a 3 inch group at 200 yards.
Excited to say the least.
Labradar is awesome.
Thanks everyone for guidance!!
cohunt
Well-Known Member
Thats moving pretty good for a 140 in a 270w, I get about 3150 with lead core 130's in mine.
That's awesome
What was case fill like with the 4350?
59.5 was pretty full with those long bullets. Slightly compressed.
