7mm stw brass trim length

doublebull82

Member
Joined
Jan 28, 2015
Messages
16
What length are you guys trimming your brass to my book says 2.840 but I have some once shot nosler brass that measures 2.830 just wondering if I should keep them at Since I have winchester brass that's 2.840
 
Most factory brass is going to be a breath short.
As it fire forms... it may get a breath shorter due to brass flowing to the specs of the chamber... however, the growth is almost always done thanks to the sizing process..
be it small base dies , FL dies.... or neck sizing only.
Long story short... it's a few thousandths diff... but if you want to maintain the best consistency with loads trim your brass to X length AFTER they are fire formed.
 
The SAAMI spec for brass length is 2.830" - 2.850". Unless you measure your chamber and trim based on the actual measurement of your chamber, you need to stay within the SAAMI specs.
 
Warning! This thread is more than 9 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top