Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
700 Bolt Extraction Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Timnterra" data-source="post: 2237432" data-attributes="member: 55944"><p>To be clear of what I think the problem is. I believe you accidentally improperly set the headspace the Remington extractor when deformed can slide out blocking the case from seating completely into the bolt face. If you are doing what i assume to be a remage set up from preferred barrels then I also assume you established headspace by screwing the barrel down till it contacted the go gauge and tightened the barrel nut. If the headspace gauge was caught on a faulty extractor instead of seating all the way down Into the bolt then you have a headspace measurement that is about 100 thousands too long and will never extract no matter what you feed it or what bolt you use. This is why your sons bolt would not work either. The extractor never snaps over the case because it can't reach. Do this for me to easily confirm or deny. Snap the no go gauge into your bolt under the extractor and feed it in to see if the bolt closes. If the bolt closes you have confirmation if not then it is a really odd situation indeed</p></blockquote><p></p>
[QUOTE="Timnterra, post: 2237432, member: 55944"] To be clear of what I think the problem is. I believe you accidentally improperly set the headspace the Remington extractor when deformed can slide out blocking the case from seating completely into the bolt face. If you are doing what i assume to be a remage set up from preferred barrels then I also assume you established headspace by screwing the barrel down till it contacted the go gauge and tightened the barrel nut. If the headspace gauge was caught on a faulty extractor instead of seating all the way down Into the bolt then you have a headspace measurement that is about 100 thousands too long and will never extract no matter what you feed it or what bolt you use. This is why your sons bolt would not work either. The extractor never snaps over the case because it can’t reach. Do this for me to easily confirm or deny. Snap the no go gauge into your bolt under the extractor and feed it in to see if the bolt closes. If the bolt closes you have confirmation if not then it is a really odd situation indeed [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
700 Bolt Extraction Problem
Top