7 FCP

[koja]

fclassproducts.com 7mm-6.5PRC Anybody have one an SP yet,looks like F class folks tiring of Saum brass scarcity. Good read on converting Lapua vs Peterson in 7FCP.
I talked to a smith about a 25Prc or 7saum barrel for an XP, this was brought up.
Fclass products sells reamers,gages and dies.Check out their Autodod case lathe,seen one of these run in person,neat $$$ machine,fellow was inside and outside neck turning one pass.

 

[FURMAN]

Bryan has an entire thread on accurate shooter about it.

 

[Ernie]

I don't have one

 

[just_jon]

I don't have one

Yet.

 

[rickiesrevenge]

That autodod looks slick. But the cartridge lost me at PTG for the reamer

 

[koja]

Ah yes ptg,they took most of a year to get my LH SA Magnum Savage bolt head,then it had a nice burr around primer hole.
But, the 7 fcp looks interesting.Lapua 6.5 prc brass seems to be available,places that run out,seem to get it back in.
About that dang Autodod. I think it put spell on me.
I asked the fellow with the autodod if he would do brass for hire,be for the 25 and 7 cal project, No
He is only set up to do one cartridge,from NOS no crimp L-C brass,20 vartag.
I was so impressed with his operation,I came out of his house with a coffee can full of new 20 vartag brass. A call to Troy for a barrel..............$$$ lighter.

 

[Ernie]

Aaron,
Cortina's wildcat (7mm-6.5 PRC) uses a Manson reamer as far as I know.

 

[ChrisRhodes]

Aaron,
Cortina's wildcat (7mm-6.5 PRC) uses a Manson reamer as far as I know.

There is a bunch of improvement options to the 6.5-prc case and Manson makes/stocks those reamers

Ptg is horrible…..avoid them at all cost.