6x45 Finally Assembled

sambo3006

Well-Known Member
Joined
Jul 30, 2004
Messages
1,393
Location
SW MO
I just got my 6x45 fully assembled. I've put together some lowers before but this was my first build from all component parts. No special AR tools but everything went together without an overage of fuss. Specs:

Anderson lower
Anderson Light weight sport upper
Phase 5 Nitrided BCG
AR Stoner 20" stainless HBAR contour barrel in 6x45 cal 1-8" twist
Sand blasted by a buddy
Magpul FDE furniture
RRA 2 stage trigger
Carbon fiber free float tube
Geissele low profile gas block

Weight 7.4 lbs as shown. I plan to use some light weight rings and a Leupold 2-7.

For some reason the buttstock and grip look like a different color in the picture but they are both the same.

I have dies, brass and bullets, just need to find my shell holder!
 

Attachments

  • SAM_0312.jpg
    SAM_0312.jpg
    118.7 KB · Views: 128
Congrats!

Shot my 6x45 build tonight. Same barrel and buttstock as yours!!

58 gr Hornady ZMax over Benchmark (at the bottom load recipe) was VERY good at 300 yards.
 
Very nice, I would like to have the upper you have on this one for my RRA AR 15. What did e upper assembly cost all together?
 
Warning! This thread is more than 10 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top