6x284 Norma Info

I recently chambered a barrel in 6x284 (Schneider polygon 8 twist). I haven't shot it yet because I don't like the throat that reamer has. I need to order a throating reamer and fix it. I made a couple of rounds by necking down 6.5-284 Lapua brass with a Hornady neck sizing die (not caliber specific but diameter specific) I then ran it into a 6.5-284 body die to make sure I didn't push anything out. I then ran it over a 6mm K&N expander mandrel. I seated a couple of bullets with the 6.5 die and found that the throat was way to short for my liking. I have a set dies now but haven't tried to size anymore down.
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top