6.5 cm internal case neck scratches

Lompoc

Well-Known Member
Joined
Aug 12, 2019
Messages
151
Location
Lancaster CA
Hey all newbie here .I have a 6.5 cm and I was preparing some new Hornady brass for reloading .I was chamfering the case neck and noticed that on some of the cases my hand got wobbly and I left some rings and scratch marks on the inside of the neck. Will this cause more pressure or affect accuracy if I load them any info would be greatly appreciated thanks
 
Pressure, probably....not? Accuracy, maybe? But since this is new brass, I wouldn't worry too much, if at all, about it, unless they're deep gouges?
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top