• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

375 Caliber 333 gr. T50 Question

jbs2014

Well-Known Member
Joined
Dec 31, 2015
Messages
1,294
Location
Arizona
I recently purchased some of the 375 Caliber 333 gr. T50 solids from IQ metals to see how they shoot in my gun. I was going to load them but could not find any load data for them. I asked IQ metals for load data and they flat out refused. I found this odd because every bullet manufacturer that I have used publishes load data for their bullets.

Do any of you use those bullets? Have any load data that you would be willing to share?

Thank you
 
I can put it into QuickDesign and/or QuickLoad.

Length
Length of boat tail
Diameter of boat tail

COAL you want.
 
Oh and those are pretty sharp looking bullets. I'm on the look out for high BC 375 that will work in a 12 twist.
 
I can put it into QuickDesign and/or QuickLoad.

Length
Length of boat tail
Diameter of boat tail

COAL you want.

I am not sure what the factory COAL should be.

Length is 2.078
Length of boat tail is .237
Diameter of boat tail (I assume at the base?) .319

Thank you ever so much for doing this. If you are ever in KS I owe you a beer
 
OK Got it.

It's too late for me to run out to the shop and measure the 375 CheyTac. Tomorrow.

It's a long bullet. Seated to "factory" coal over 1 inch of bullet is inside the case. That's not gonna work.

Do you have a COAL gauge and a CheyTac modified case? If not PM me about me about getting one.
 
Warning! This thread is more than 9 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top