Reamer has cut one chamber by my gunsmith. It was setup as a "max effort" 338 Lapua as far as throating with the 300 gr Berger. Boat tail junction is right at or slightly above the neck/shoulder junction.
The neck is no turn for most brass, a bit tight on Lapua brass. You may need a skim cut. ( I do/did not with Lapua or Peterson Brass)
This runs nicely out of a Wyatts CFE-9 mag box in a BDL setup.
338 Lapua Mag PTG bushing pilot
0.3708 neck
0.256 freebore
43841 drawing
Manson go gauge
$200 shipped for set.
The neck is no turn for most brass, a bit tight on Lapua brass. You may need a skim cut. ( I do/did not with Lapua or Peterson Brass)
This runs nicely out of a Wyatts CFE-9 mag box in a BDL setup.
338 Lapua Mag PTG bushing pilot
0.3708 neck
0.256 freebore
43841 drawing
Manson go gauge
$200 shipped for set.
