Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
300 wsm sizing problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rod-in-montana" data-source="post: 22247" data-attributes="member: 469"><p>the last time out shooting i watched my buddy bulldog'n the bolt closed and thought he had the bullets out to far.so when he reloaded i checked the bullet-land spacing and had the bullet set .030 off the lands.today at the range i shot his 300 wsm and the bolt was closing very hard on his loads.so i suggested after wrestling the bolt closed that his cases must be to long.some were a little long, after trimming and chambering without a bullet in the case it was still tight,i set the rcbs fl die all the way down to full size and it is still to tight.i neck size all my stuff and never had this come up before.what do you feel is going on? it doesn't matter if the cases are once fired factory or low to hot loads.his rifle is a win. factory.the stock rounds feel just fine chambering.and handloads are printing .5" groups at 100yds.</p></blockquote><p></p>
[QUOTE="rod-in-montana, post: 22247, member: 469"] the last time out shooting i watched my buddy bulldog'n the bolt closed and thought he had the bullets out to far.so when he reloaded i checked the bullet-land spacing and had the bullet set .030 off the lands.today at the range i shot his 300 wsm and the bolt was closing very hard on his loads.so i suggested after wrestling the bolt closed that his cases must be to long.some were a little long, after trimming and chambering without a bullet in the case it was still tight,i set the rcbs fl die all the way down to full size and it is still to tight.i neck size all my stuff and never had this come up before.what do you feel is going on? it doesn't matter if the cases are once fired factory or low to hot loads.his rifle is a win. factory.the stock rounds feel just fine chambering.and handloads are printing .5" groups at 100yds. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
300 wsm sizing problem
Top