22 Creedmoor Dies

Gwine

Well-Known Member
Joined
Mar 3, 2013
Messages
423
Location
Southern Oregon
What are you guys using for dies? I'm ordering parts for a build and am having a difficult time deciding on dies.
 
Redding 6.5 Creedmoor type s dies with a smaller bushing and a generic 22 Hornady seater
 
I'd go whidden or use 6.5 creedmoor redding type-s bushing die with 22 cal sized bushing based on the brass and bullets you use.
 
I'm the same as Elnicko above. I got Hornady but only use the seater, as the sizing die has a large decapping pin and my brass is lapua SRP 6 creed. Haven't found anywhere that Hornady sells small decapping pins
 
Thanks for the replies guys. I ended up picking the Hornady and got their micrometer seating stem accessory. Should have them next week sometime, but am still ~12 weeks out on the build parts.
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top