Looking to see if anyone has experience with the 130 Grain Shock Hammer in a 6.5 creedmoor. I was wanting to try RL26 with this combo, but would also take some load data from other powders.
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
130 Grain Shock Hammer Info Needed
- Thread starter Stewart2550
- Start date
Help Support Long Range Hunting Forum
Stewart,
No data on that combination on the spreadsheets. Best bet is use 6.5 CM 124 data, start on low end and work up to pressure.
Look at Hammer Hunter Load Data on this forum.
Please be sure to share your rifle/load data when you're done
No data on that combination on the spreadsheets. Best bet is use 6.5 CM 124 data, start on low end and work up to pressure.
Look at Hammer Hunter Load Data on this forum.
Please be sure to share your rifle/load data when you're done
Rich Coyle
Well-Known Member
Before my 6.5 was
reboard to 8 mm I used 130 shock hammers. I once shot a 330 pound pig and had about 30" of penetration. I found where the shank and 3 of the pedals had exited.
Stewart,
No data on that combination on the spreadsheets. Best bet is use 6.5 CM 124 data, start on low end and work up to pressure.
Look at Hammer Hunter Load Data on this forum.
Please be sure to share your rifle/load data when you're done
reboard to 8 mm I used 130 shock hammers. I once shot a 330 pound pig and had about 30" of penetration. I found where the shank and 3 of the pedals had exited.
