Recommend a powder scale?

Now I just need to get a decent powder pan. I never really liked the Dillon pan, it's a little small.
Any recommendations?
 
Last edited:
What I find hilarious is how many guys use electronic scales but check them, some every load, against a balance beam. That pretty much syas it all about how little guys trust their electric scales. Why not just use the balance beam from the get go, or learn to trust the electric. It is really easy to tell if an electric has drifted, you can check it every time you take the pan off the scale to dump the powder. I have more faith in my powder throwers than many of you demonstrate for your electronic scales.
Well sir, it is apparent that you have not used one. They are a great tool for loading accurately, but being a machine, they need to be checked and confirmed regularly. There is usually a "check weight" included when you buy a scale. They are also susceptible to power surges and other disturbances. And no, it is not easy to know when they have been subject to a fluctuation event.
Also, I double check all aspects of loading in any run to prove consistency throughout. Using a gravity powered tool to cross check periodically, is just good practice.
The beauty of a scale like the A&D, is that you can load charges to .02gr consistently, at a rate of 6/minute (+/-)
 
Well sir, it is apparent that you have not used one. They are a great tool for loading accurately, but being a machine, they need to be checked and confirmed regularly. There is usually a "check weight" included when you buy a scale. They are also susceptible to power surges and other disturbances. And no, it is not easy to know when they have been subject to a fluctuation event.
Also, I double check all aspects of loading in any run to prove consistency throughout. Using a gravity powered tool to cross check periodically, is just good practice.
The beauty of a scale like the A&D, is that you can load charges to .02gr consistently, at a rate of 6/minute (+/-)
Your assumption is incorrect. I have two electronic scales I use regularly. I use a 40.03 grain Vmax and a 180.02 grain Berger for check weights, along with the 70 grain weight that came with the scales, no need to spend money on the high end check weights. All you need is something of known weight, you aren't selling diamonds by the Carat. As far as checking the scale, if it doesn't zero every time you take the pan off, it needs to be calibrated. I have never seen a fluctuation event that left the Tare intact. You can put the check weight on every 15 or 20 loads and easily verify set without using a "gravity" powered device.Electronic scales do not drift out and back in again, if they did they would be totally useless.
 
Last edited:
Top