Chamber a 338 edge with a 338 rum reamer?

I've never done this with a 338 RUM specifically, but I've run quite a few reamers deep to stretch a chamber for a wildcat idea. You'll usually end up with a slightly over sized chamber at the case web, but it's nothing I've ever worried about. I've created a similar situation by using 404 Jeffery brass for RUM based cartridges. The 404 case is slightly smaller at the web than a standard RUM case so you end up with a bit of a bulge. It's never been an issue for me and I've done some TERRIBLE things to that brass and it's still going strong.

You can always run 338 Edge cases into a 375 RUM die to size down the web and use a 338 RUM die to neck size and bump the shoulder if you don't want to get the Edge dies.
 
Rent the reamer from Dave Manson or PT&G. Ought to be less than $100 for a month or some period of time. Beats having a reamer made. I know-- I've had two made for my wildcats...
 
I've never done this with a 338 RUM specifically, but I've run quite a few reamers deep to stretch a chamber for a wildcat idea. You'll usually end up with a slightly over sized chamber at the case web, but it's nothing I've ever worried about. I've created a similar situation by using 404 Jeffery brass for RUM based cartridges. The 404 case is slightly smaller at the web than a standard RUM case so you end up with a bit of a bulge. It's never been an issue for me and I've done some TERRIBLE things to that brass and it's still going strong.

You can always run 338 Edge cases into a 375 RUM die to size down the web and use a 338 RUM die to neck size and bump the shoulder if you don't want to get the Edge dies.
That was my original edge sizing setup. 375 fl and 338 neck
 
let us if for sure it works it should
I already built one that way. I did the math and found it gives me a .091" flat at the start of the chamber which hasn't caused issues chambering a round or resizing as of yet.
It allowed me to use the 338 rum dies without messing with custom dies or buying expensive edge dies
It allowed me to use one reamer for 338 rum and edge chambers.
I was asking the question to see if anyone else used this method for edge or other chamberings. Can't imagine you couldn't make a 30-28 nosler with a 30 nosler reamer, using 30 nos dies .... haven't done a drawing on that one though
 
Not sure if this is permitted but,4-D reamer rentals has the Edge reamer,and Redding sells the Edge dies as standard dies under the heading of 338/300 RUM. And yes,it works perfectly,and you rent the reamer by the week. Call ahead because it is a popular reamer.
 
I already built one that way. I did the math and found it gives me a .091" flat at the start of the chamber which hasn't caused issues chambering a round or resizing as of yet.
It allowed me to use the 338 rum dies without messing with custom dies or buying expensive edge dies
It allowed me to use one reamer for 338 rum and edge chambers.
I was asking the question to see if anyone else used this method for edge or other chamberings. Can't imagine you couldn't make a 30-28 nosler with a 30 nosler reamer, using 30 nos dies .... haven't done a drawing on that one though
what and how did you headspace
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top