Load for 30-06

If you go with a partition then get a box of speed hot-cores and load them up the same as the partition. They will probably shoot very close to the same poi and are much cheaper to practice with.

Any good 165-168gr bullet, work up to 58gr IMR4350 (or Hodgdon) Zero +2" high at 100yds.

My load I ended up with is:
Winchester brass with cci primers
53.3 grains h4350
200 nosler Accubonds
Coal 3.300
Velocity 2535 out of a factory 24 inch barrel.
Group is .7 at 100. Load still carries a ton of energy out to 600 yards.

I used 60gr R22/200PT for years in a Model 700 CDL. It was a real killer.

If no further than 400 yards I use 60 grains of RL-17 WW brass Fed 210 primer and a Barnes 150 gr TTSX. Opens on deer, will hold together on Moose and Elk and shoots nice groups, oh ya almost 3100 fps out of a 24 inch Remington Barrel doesnt hurt either. As always this load is safe in my rifle, reduce by 10% and start from there.