The ADG is finally here.
- Thread starter Deviant
- Start date
-
- Tags
- adg 6.5 saum
Help Support Long Range Hunting Forum
Shane Lindsey
Well-Known Member
- Joined
- Jul 13, 2010
- Messages
- 3,344
I am using it in my 300 RUM. It seems to have a little lower capacity than others. At least I am seeing pressure a little earlier than I want to. Also when I chamber a round and remove without firing, I get swipe, similar to what I get with Norma.
That is a sweet set up. I like the stock. Did you paint that stock or is it factory from Manners?
That is a sweet set up. I like the stock. Did you paint that stock or is it factory from Manners?
That is the Manners midnight camo. I did paint 2 others just like it to match but not this one.
SwampDog13
Well-Known Member
Just ran 50 rounds of 6.5saum using ADG brassthrough my new rifle for break in and fire forming. I was pretty happy with the initial consistency of the brass. Really looking forward to round two with load development.
ramrod79
Well-Known Member
Nice Rig I like that midnight camo pattern.
I use the ADG in my 338 Sherman Short. Just started on 4th firing of 50 all still good. I have nothing to compare with this cartridge as I started with ADG. My 6.5 Sherman I ran Norma it also worked really well I stated culling brass on 6th firing.
I use the ADG in my 338 Sherman Short. Just started on 4th firing of 50 all still good. I have nothing to compare with this cartridge as I started with ADG. My 6.5 Sherman I ran Norma it also worked really well I stated culling brass on 6th firing.
The Oregonian
Well-Known Member
I have 100 pieces of 28N en route...will use it when my primer pockets crap out on my Nosler brand. I'm at three firing and they are noticeably looser than new.
Details on build (especially the stock)?
Guinness
Well-Known Member
And the rings? I like how they're the same width as the single slot rail of the Deviant UL. Thanks.
G
G
TPS TSR ultra low rings.
I missed out on there first short run of 6.5 brass so I bought the 7mm brass, necked it down and turned it. I just did a pressure test Saturday, I was able to get a little more speed compared to the Hornady before I hit pressure. Still need to do some load development then see how well it holds up.
