TonyRumore

There are very few barrel makers that can do that 1:3 twist. 1:5 is the normal limit for most. If you're planning on shooting subs...

The scope mount sits parallel to the bore. Tony

That sounds like a good plan. However, I am guessing the scope/reticle is setup to be installed on a 20MOA downward slanting mount...

It came on a Pauza P-50 semi-auto 50BMG when I bought the gun. Tony

I'm not exactly sure how I'm going to get this sighted-in at shorter ranges. Starting off with a newly mounted scope at 500 yards, is...

That bullet is extremely accurate in every single 6mm gun I have ever tried it in. They also kill deer quite well. I've been using it...

This is not correct. The serialized part can be swapped out for a different one with no 4473 required. See ATF link below. Tony...

Call Ben Syring (pronounced "searing") at Hornady. 800-338-3220 extension 261. He will need a chamber reamer print and three fired...

Back in the 80's I used 120 grain Barnes originals in mine. Ruined a lot of meat, but I had a lot of DRT's. Tony

I have a 6mm-6.5 RPM on a left hand deluxe Weatherby action, but not a 25 RPM. Tony

I have about a dozen left hand Mark V Deluxe Weatherbys. The German and Japan guns shoot OK, but not great, however my 6.5-300 Sheridan...

There would be no bolt lug issues if the bolts were made from Vascomax 300. It's only a $1,000 per foot for a piece of round bar. Tony...

Unfortunately not. I have it loaded up in my 375 SOCOM, and 375 Auto Mag as well, but haven't found anything to shoot with it yet. I'm...

I've been using AR Plus in my 16" Raptor AR-10. 50gr of AR Plus behind a 220gr Fury Spitzer runs 2428fps. Tony

Last year my wife and I rented a BMW 1250rt in Barcelona Spain and toured through the Pyrenees mountains (Spain/France) for a week. That...