Recent content by tayhot

bump. need it sold

Make an offer

Custom 338 RUM Rem 700 action, trued/accurized 28" fluted Benchmark barrel in #4 Holland's Muzzle brake (recoil equal to .243 Win) HS Precision stock Action bedded and floated Jewell Trigger Tubbs oversized recoil lug Talley Rings and bases (bases are bedded) Two tone Duracoat finish Leupold...

Bump

Ready05. What is your email?

I have pics from my chrono to document

KRL1116, I sent you a PM

It doesn't weigh much more than a factory rifle. I'd say between 8-9 lbs. I can weigh it later and get back to you. I don't remember the contour, but it's either a #2 or #3.

I am selling my custom built .257 STW rifle. This rifle has less than 50 rounds through it and is by far the most accurate rifle of all my custom builds. It will shoot overlapping holes at 100 yards and has a 2" group at 400 yards. 100 gr TTSX traveling at 4060 fps is simply amazing and deadly...

How difficult is it to install a Limbsaver pad on HS Precision stock? What Limbsaver part number would be needed?

Thanks guys. Ended up going with Warne 20 MOA 1 piece base and Warne Tactical rings. Should be a good combo

ordered a Sightron sIII 6-24x50 scope to go on my new 338 RUM. Action is Remmington 700. Can I get some suggestions on rigs and bases? I've always used Talley rings and bases, but want to go with 1 piece base with 20 MOA built in. Thoughts?

I'd like a pic. [email protected]

SBBruce, your "scientific" test was correct. The Noaler once fired needs a press to seat the bullet

I did go though all my normal brass prep (case trim, chamfer, debur, etc). This was virgin Nosler brass. I take the 7mm STW and neck it straight to 257 with my RCBS FL die. I have never had an issue with this with remmington brass I did seat the bullets .005" further out and thought maybe...