I shoot 6.5x284 in F Class competition but haven't shot any game with it.
I have two loads I shoot and both have been very accurate. I shoot Moly out of my 6.5 so if you aren't shooting moly these loads will be too hot so be careful and start with lower powder charges. Accurateshooter also...
Any chance of a little video footage of this thing in action in the near future? I'd like to see someone behind the rifle working the bolt. It looks like it would be slightly cumbersome at first glance.
Found a really cool page at Brown Precision with weights of different actions and components.
Selecting Components for Lightweight Mountain Rifle from Brown Precision, Inc.
The Remington 700 TI actions aren't listed does anyone know the exact weights of the 700 TI actions?
I tried to shoot the one on the left twice. My firing pin doesn't strike the primer exactly in the center. I had rotated the case a little bit before trying again.
Had an opportunity to do some shooting today and I had two primers fail to fire in my 338. The primers are CCI 250.
I am hoping for a little help figuring out if it was bad primers or if my firing pin isn't striking the primer hard enough.
I had taken 6 shots and the first failure...
I have a Coues Whitetail hunt this year in the high desert here in Arizona. The closest water source is 5 miles down the trail from where I intend on hunting. I'm packing in 3 gallons of water that I'll stash and mark on my gps this weekend to make sure water is there when I need it. I have a...
So the DE brake comes with specific instructions NOT to turn the brake diameter down any more than it already is. I assume this is because the material on top/bottom of the ports would become too thin. So a slight taper was used to meet the contour of the barrel.
Re: 32% of you use a ballistics program and hand-held device in the field - which one
Used IPod Touch with Ballistic for a long time. Just picked up a Motorola Droid and downloaded Shooter for it. Haven't used it out in the field yet but just messing around with the features, I like it better...
I can post a good pic when I get home but there is a slight taper on the brake to meet the barrel contour. The DE brkake cannot be turned to a smaller diameter near the ports.
To do the texture:
1. Tape off the area you want to texture
2. Spread a fairly thin layer of epoxy evenly over the area (I used Devcon)
3. Let it setup for a little while until it starts to get tacky. I think I waited about 40 minutes or so.
4. Take a popsicle stick or something...
I shoot 48.5 gr. H4350 w/ 139 Scenars (Moly) and 50 gr RE17 w/ 140 Berger VLD (Moly). Shoot these in Midrange matches and both have done really well. The 139's shoot a little better than the 140's. I get 3014 fps with the 140's. Lapua brass, CCI br2 primers. Both are seated to the lands...