Recent content by Seven Oaks

Re: $2,500 Outfitted Antelope or Black Bear Hunt Giveaway Contest - Redbone Outfitter "Enter me in the Redbone Outfitting contest"

Re: $2,500 Outfitted Antelope or Black Bear Hunt Giveaway Contest - Redbone Outfitter Enter me too!

They both are accurate, both are flat shooters, both deliver excellent down range performance on game. The mag capacity is 3 on both rifles. The 7MM uses bullets that have a little Higher BC. The 300WSM offers a hunting bullet selection above 175 grains. The 7 Mag does not. The real...

I have Browning X-Bolt in 7MM WSM and haven't run into any feeding problems yet. I've only been shooting the rifle about a week now. The Browing reciever design makes single feeding tough, so I just load up the mag and cycle thru. 60 rounds thru it and no trouble so far.. It's a push...

It's got to be my Uncle hands down. Joe with the " Missouri Monster". I can't wait until he sees this....

Hi Jim, I did and thank goodness its o.k. I didn't believe that first bird I talked to at Browning so I never ran the screws up to 65 in/lbs. only 45. I pulled her apart and looked and they appeared to be sharp and there wasn't any marks on the end of the action screw to indicate that it...

Hi Montana, Mine works just fine. In the instructions it says after use wind it back down to it's lowest setting so the internal springs won't give out. It is set in 10 in/lbs increments. There is a slot with a small block that travels up and down that you align with numbers printed on the...

Anybody know of a good way to clean up some old antlers? I've got some that hung close to a fire and turned almost black from smoke. Any suggestions appreciated. D.

Thanks guys. Appreciate the help. D.

Hi J.E. I was unable to find that post your referred too. To make matters worse, I called Browning again this morning. This Tech said they had no specification but used 35 in./lbs at the factory??? The mystery deepens. Good grief, you would think Browning would have their act together on...

Thanks A.J. I use a Wheeler Fat Wrench. I appreciate the article link as well. I feel better now.

I Love Leupold and like Nikon very much. I recently ordered a Nikon Monarch X 2.5 x 10 x44. It has a 30MM tube. I contacted Nikon and was told X line of Monarch scopes has a more robust/precise internal adjustment mechanism than the Monarch Gold. It's there best system. Also features a glass...

Recently got a Browning X-Bolt Hunter and wanted to adjust my trigger. You have to remove the bottom metal screws which are also the screws that secure the barreled action to the stock. In the Browning owners guide it simply said to snug the action screws back. Pretty lame instructions- So I...

Varmint Hunter, you made me laugh. Thanks. I lapped my dovetail Rings. I also have a DNZ 30MM Gamereaper mount and I didn't lap them per instructions not too. For years I didn't bother doing it as I shot rather mild recoiling calibers (.35 Rem, .308, & .270 Win.) I started doing it with my...

My other Factory Bolt guns are 1 MOA or a little better (7/8) shooting certain premuim factory ammo at 100 yds. and I'm tickled with that. Done a little work to them but nothing major. The groups stay about the same to 200 and start opening after that. I have a new 7MM WSM X-bolt that I...