Recent content by Roninco

Use extreme caution when using canned compressed air. The propellent super-cools the air as it exits the can and can thermal shock the glass. Reputable scope manufacturers will repair the cracked lens; but maybe only the first time. Pressurized air from a compressor does not exit super-cooled...

Without knowing your specific brass characteristics and cartridge overall length, a quick run with Gordon's Reloading Tool shows 41.7 grains of H4350 at 65 degrees has a maximum pressure of 70542 psi. Maximum allowable pressure is 62000 psi. Use this information for reference only.

I have been reloading my 6 Creedmoor using H4350 with acceptable accuracy and velocity but I'm willing to try some other powders. Bullet is 108 grain ELD-M in Lapua SRP brass through a 24" barrel. I usually use Federal 205 primers but also have some CCI 400's. Powders I have available are...

I have 5 pounds of these chips for sale. $35 shipped. PM if interested. https://www.ammobrass.com/product-page/stainless-steel-cleaning-media-chips-for-wet-tumblers

This one works for me.

Excellent opportunity for someone in need. This is an exceptional value. Hope you find a buyer.

I have not received the Daily Newsletter since Monday, May 15. Was it issued this week or is the problem on my end?

I just saw this notification on the Powder Valley website: "ATTENTION: Beginning at 11 PM CST, 05/16/23, we will be upgrading our systems and migrating the domain URL from PowderValleyInc.com over to PowderValley.com. During this time the site will be down. We expect to be back online by 3:00...

Muzzle brake 10-12" in front and barrel 8" to the side of the unit. Set the lateral offset in the "Configuration Menu" under "Set Proj. Offset". Instructions on page 10 of User Manual. If you have issues LabRadar personnel are very helpful: [email protected] or 316-866-2525. Aim the unit as...

A coworker recommended Sportsmans Insurance Agency. He reported good service with claims. https://www.siai.net:8443/

Excellent suggestion.

This is why I make a chamber length gauge for each of my rifles. It allows me to know what my trim length actually needs to be. https://www.brownells.com/reloading/measuring-tools/case-length-gauges/sinclair-chamber-length-gage/

Cut the barrel back, recrown, and give it a go again. You'll lose a bit of velocity but will minimize barrel whip.

I will take the other 3 box lot. Will send PM soon.

Kestrel Ballistics offers periodic virtual classes which are very helpful in learning how to use it. Sign up via the attached link for notification of when the classes are offered. https://kestrelballistics.com/classes