Rhovee's Recent Activity

  1. Rhovee posted a new thread.

    Want To Buy Redding Type S FL bushing 7SAUM

    Title says it all. I am building a 7 SAUM and am looking for some Redding Type S Full Length Bushing die's.

    Forum: Reloading Equipment and Components

    Feb 17, 2018 at 10:23 PM
  2. Rhovee replied to the thread Load work up...seating depth test first OR charge weight first?.

    Yes I have found that to be correct. It can obviously make different shapes and move horizontal and vertical until it fine tuned. It’s...

    Feb 16, 2018 at 11:50 PM
  3. Rhovee replied to the thread Want To Buy Manners eh1 - proof barrel.

    Ryan pierce sells new eh1s for 600. So does stockys stocks.

    Feb 16, 2018 at 10:14 PM
  4. Rhovee replied to the thread Load work up...seating depth test first OR charge weight first?.

    If .020 shot great at a lower powder charge, I would shoot groups of .006 each direction going .003 at a time cause i know i am close....

    Feb 16, 2018 at 6:41 PM
  5. Rhovee replied to the thread Load work up...seating depth test first OR charge weight first?.

    If I had great luck on .020 on a lower powder charge and was shooting a ladder and had things go horizontal, it would be .015-.018.023

    Feb 15, 2018 at 3:55 PM
  6. Rhovee replied to the thread Load work up...seating depth test first OR charge weight first?.

    All my rounds are measured off ogive. I have seen it when shooting a ladder as well. I have had a lower node shoot a triangle size...

    Feb 15, 2018 at 3:10 PM
  7. Rhovee attached a file to the thread Load work up...seating depth test first OR charge weight first?.

    Here was my latest experience. Loaded some coal. Increasing charge weights. All three shot groups looking at lower set. Pretty clear...

    3979D1E5-2763-4C1F-9218-1C27C72A09DC.jpeg Feb 15, 2018 at 1:45 PM
  8. Rhovee replied to the thread Load work up...seating depth test first OR charge weight first?.

    I use to do seating first. If I have a good use from a gunsmith on seating depth with his reamer based on previous loads I will use...

    Feb 15, 2018 at 10:37 AM