Recent content by Mysticplayer

You have to start with the case and measure the neck dimensions OR you can outside neck turn and make it exactly what you want. I much prefer outside neck turning to control my brass and neck tension. choose say 12 thou thick neck and order your bushings to suit. 1 to 2 thou of neck...

Depends on the dimensions of the chamber vs your ammo. how well the action locks up vs the pressures you are running What type of function requirements you must have. EVERY cartridge can have and use ALL the same techniques. It doesn't matter what it is, just what it is fired in and how...

You are correct - 1/2" at 50yds is essentially 1MOA (round off math but close enough for what we are doing). If you find you do not have enough UP to reach where you want, start with a much higher 100yds ZERO. Most of these reticles have some markings above the center which can be referenced...

vgJaHnYYhv8 Here is the ASSEMBLY Video. Easy to put together and simple to change various parts to suit almost any end use. Enjoy... Jerry

Given the profile of the MPOD, it easily stores in my rifle case unlike most other Skipods on the market. The light weight isn't a chore either. Will fit easily in most any hunting backpack assembled. If you want a smaller profile, you can take it apart further. Would break down into a...

Appreciate the kinds words and feedback. We can make custom feet , front plates (different stock widths) and leg lengths. Given the modular nature of the design, you can change various parts to suit. In the works are different plates to suit various stock widths (already make a 3" wide for...

Thanks So far, feedback from customers has been very positive. Jerry

Len approved this post. Been busy the last year developing a new bipod that will work very well for those looking for a more stable rest but not have alot of bulk. 12.8oz on the rifle and it can be made even lighter if you swap out the knobs and lever You can learn more about it here...

mLAU_Bc5Wdw My new Bipod suitable for F class and LR hunting. Thought you guys might like to see the new product video. Len approved this post. [email protected] for more info. Thanks and enjoy... Jerry

You are doing the same math regardless of how you think of it. The scope adj's are usually in MOA so at some point you will have to figure out the number of clicks that you need to reach out. You will have to convert the number of inches to moa/mins so that you can figure how many clicks on...

Factory cases should already be annealed. If you have formed from 8mm RM, it wouldn't hurt. I use Titegroup but Red dot and HP38/Win 231 can also work. I would go with around 8 to 10gr of titegroup and work up. Faster powder, start lower, Jerry

I do not use the Coax press but many others do. I do all my loading right now on a Lee Breech Lock Challenger press. First decide how you are going to use the ammo/rifle and the type of clearances you will need. Match ammo can be dead tight. Working ammo or dangerous game ammo better have a...

FF with pistol powder and cornmeal. Simple and effective. Jerry

Recent shooting with Norma brass impressed with how well it was made. And it was also quite durable. Will Win be as good out of the bag? Highly unlikely but you can prep that brass and make it very good. I have a 7-300WSM project on the go and will use Win 270WSM brass to start. I will do...

I prefer to neck size, body size then seat. If the FL sizer matches your chamber well, then that works good as any method. The problem is what if it doesn't match? I am sure intime, other companies will get on the 338LM bandwagon and start offering dies. I would love to see Lee make a...