mdmiller's latest activity

Brux barrel. Woodman Arms muzzle break trigger tech trigger. Stockys stock. N120 powder.

Every time I go out to shoot I end up grabbing the bow instead and sitting in my stand. Hunting season happens. I was going to try to...

Ok, so it's a hollow base bullet. Otherwise even soft copper flat based bullet would barely flare to engage the rifling.

Hammer list it as 1:30.

Not quite sure I fully understand the above ? A properly sized bullet should not be a PITA to load. An improperly sized bullet could...

Soft brass, or copper without a sabot, would still be a PITA to load! Copper would be the easier of the two to get the rifling to engrave.

Hmmm. THAT is a good question!!!! I would assume that the bullet manufacturers would list a twist rate for different weight bullets...

Would most muzzleloaders have the appropriate twist rate to support copper monos ?

Any range results yet? I picked up a Traditions Strikefire inline in 45 caliber. Thought about using 40cal Hammers or CEB.

Following. I have used the CE in mine with the Harvester Green Sabots. It kills.

I tried this endeavor 2 years ago and failed. Was trying to go the sabotless route though. I tried swagging down the .458 and then the...

🤣 come on fellas! Everyone knows it’s the the DoAll 6.5Needmore❗️🤣🤣🤣🍾🍾🍾

22CM....If you want a real hold on hair yote smoker to 400yrds 20-250Ai.

6PRC/SI, 25PRC/SI, 6Max, 25Max, 257Wby, 264WM, 26Nos