Recent content by MarkA

  1. M

    What bullet should I try in my 30-06

    Same Hammer results here for me in several different cartridges. My son shooting them in the 152 grain Hammer in his 30-06 with H4350 at 59 grains....MAGNUM PRIMER..... and they going 3,050fps in Savage 22" barrel.
  2. M

    6.5x284 124 hammers

    Did you test using the H4831 with Magnum Primer. I have found that due to lower bearing surface they all require a bit faster burn rate and Mag Primer seems to really help too. I'd would go faster burn rate first. So I would probably go the H4350 route. And MAGNUM primer.
  3. M

    260 loads?

    Scirroco can be very hard to tune in about any cartridge. Never got the accuracy in .260 with them or Interbonds. The 130 Accubonds will shoot very nicely in most guns. I was loading 42.5 grains of H4350, but I found the key was to start lower and chrono speeds as I worked up to speed at 2,850...
  4. M

    Calibrated Ballistics Turret is NOT Matching POI

    Good deal! That tells you the scope is moving 0.26563 inch per click. Correct value for 1/4 moa adjustment turrets is 0.26175 inch (equals .25 moa) per click. With the right ballistics program can just adjust click travel numbers and avoid sending the scope back unless you just want it fixed...
  5. M

    Calibrated Ballistics Turret is NOT Matching POI

    NO. 20 moa is 20 X 1.047 = 20.94 inches. Your scope is NOT the problem!
  6. M

    Primer seated deep enough?

    If they're not seated to slight crush fit as mentioned above it will show up in inconsistent ES's......
  7. M

    Calibrated Ballistics Turret is NOT Matching POI

    You still know nothing until you tall target test your scope. At 100 yards setup 36" or so tall target, shoot a shot with your 100 yard zero at near bottom of target then dial up at least 15 moa and shoot again with same point of aim measure the actual poi difference between the 2 shots. If...
  8. M

    Calibrated Ballistics Turret is NOT Matching POI

    Have you TALL target tested the scope to verify it IS dialing correct?
  9. M

    7 wsm powder

    H4831SC is gonna be hard to beat, I would say RL26 if you can find it. Berger can send you load info. Just email or call and ask.
  10. M

    Goto loads for 7mm REM Mag and 160 Accubonds

    Never seen a 160 AB shoot its best until at least .050 up to as much as .120 off the lands. Jump it more and see. I start at .030 and and seat .020 increments and start shooting 2 at a time. If won't group 2 no need to shoot 3rd. My 7RM sendero shoots the 140 AB best at .075 off lands.
  11. M

    .243 bullet 300 and under on deer & Barnes TSX question

    Just keep using the Barnes and sooner or later you will need a good light and some tennis shoes to catch with. My daughter and I average many (not going to say how many because it might be shocking and most are donated and all are legal) population control doe harvest a year and a very large...
  12. M

    .243 bullet 300 and under on deer & Barnes TSX question

    As well as the 95 Partition. It is generally an easy to bullet to get accuracy and will deliver good pass thru's in 99% of angle shots. It is best suited to a 10 twist barrel also. Works great with H4350 for best all around temperature use. The 100 grain Partition shoots great in some 10 twist...
  13. M

    .243 bullet 300 and under on deer & Barnes TSX question

    Had the exact same in my daughters .243....... hammer bullets will correct that problem for you.
  14. M

    Annoying pop up ads

    Add the Chrome Adblocker Plus to chrome as an extension and they go away on screen on pc. For mobile phone there are several good ad blockers out there too. https://chrome.google.com/webstore/detail/adblock-plus-free-ad-bloc/cfhdojbkjhnklbpkdaibdccddilifddb?hl=en-US
Top