Recent content by lrdevil

Will do, thank you for your help I greatly appreciate it.

I just finished chambering a 243 and the bolt will close on the go gauge but requires slight pressure, its not hard but it doesn't just fall into the closed position either, would this be too tight of headspace or could I call it good there? The action is hand tight.

Hired gun, do you actually have a fan hooked up to it as well?

That's an awesome set up, that would be perfect.

You're absolutely right, I have found a couple but they are very pricy when you consider that you could build one for a fraction of the cost. My challenge is that I'm just not an electronics type of guy so I would probably get off on the wrong foot to begin with.

It seems most people are building their own ovens, but if one were to buy one who would you recommend to buy from. Keep in mind, this would be for barreled actions.

Haha I would man if I had the balance to by another S & B but right now I share that Nightforce between 3 different rifles.

300 rum.

Those guys build some awesome rifles. I had my other 300 RUM built by Score High and with that rifle I have no problems getting first shot hits at just over a mile. Those RUM's are a wicked cartridge.

Also, I dont have a good camera, just my phone but I can post a couple different photos.

The rail is a 20 moa Larue Tactical, the trigger is the factory but the gunsmith was able to lighten it up as much as he could comfortably. The gunsmith I use is Charlie Robertson of Score High Gunsmithing, he makes his own muzzle brakes, I never shot this rifle without it so I cant tell you...

I have a 300 Ultra Mag for sale. Its pretty much like new, I have right around 80 rounds through it. I bought it brand new and had a muzzle brake installed, barrel was re-crowned to 11 degrees, it has been epoxy bedded and the trigger has been tuned. The stock is HS Precision and I am including...

Also, with regards to using levels that you set in the action and then on the scope, I kinda think the exd may work a little better, just my opinion, because assuming that the tapped screw holes in the action for the scope mount is perfectly aligned with the bore thats basically what this tool...

Yeah I had mentioned about that exd, my gunsmith is meticulous about making sure that the scopes are perfectly mounted and aligned, the only thing is it costs everytime I wanna do something different so I purchased one of these and it works great for me, I never really realized how much my...

Got some vihtavuori N150 that I plan to try in my new 6.5-284 rounds shooting the 140 grain berger hybrids. Does anyone have any experience or reviews for this particular powder? Anything helpful is appreciated.