It is a 20" Shilen I ordered from Midway
I'm sure it is SAMI, I've only fired about 20 rounds
of the Hornady SST which it doesn't seem to like much
so I'm going to try A-Max and see what happens
One reason I was thinking of using the long action for a 6.5.
I have to finish a Grendal upper before I can start on one of the 700s.
By then i will have changed my mind 10 times!
I have a rem 700ADL SA in 243 built in 1971 and a 700 BDL LA 30/06 from the early 80s. Both guns have been pillar bedded with Holland pillars and Steelbed.I have also done some work on both triggers. My plans were rebarreling the SA to a 260AI and the LA to a 280AI. I do not compete but i do...
What is a good decaping die for military
crimped primers? I have a RCBS which
works fine on commercial and reloads
but breaks a lot of pins on crimped primers.
That's one reason I haven't tried CFE
I want to leave the copper in the barrel.
I wonder if it builds up in the grooves
and gives you a better angle than 90 degrees
Most of my guns will not shoot a tight group without some
copper fouling (the 5R doesn't seem to care). For this reason
I've been hesitant to use a CFE powder. Most of these guns are
older sporter barrels but even my Shelin barrel on my AR shoots
better after a few rounds through a...