slikmrc's latest activity

Finally got my 30 nosler from gun smith. 0.050 “ off worked out great once I got the speed up. I will see if it repeats and call it...

Week in hospital now. Thank you for the prayers,it’s appreciated. Cheers.

if people would learn to read the brass and do what the brass is telling them instead of what they read on the internet most brass with...

I've got some Hornady brass on a test in 30-06 and 300 WBY. 30-06 is factory loaded ammo. 300 Wby was new old manufacture brass I picked...

Sounds like the OP has trouble shot a few things on the rifle. One thing to try is to torque down the front gaurd screw tighter and see...

FL die to chamber compatability in factory chambered rifles is all over the board as we all know. It is rare for me to over cam when...

How much shoulder bump are you seeing FL sizing new brass? I generally lower the expander ball on FL dies and just make sure the necks...

Have you measured any fired cases out of the rifle? If not I would load and fire the cases that will chamber to get some measurements of...

I have had fifteen barrels, salt bath nitrided, Some using non toxic salts (Melonited) and arsenic salts, both new barrels and used. I...

No need to compromise staball 6.5 will do very well for both, depending on gun.

Give the modified case mouth a little inside neck chamfer and see if that helps. Also you could load up a dummy round to Sierra's OACL...

I shot factory loaded 30-06 with the 175 TA. In my rifle they are .0870 off the lands. In three different outings they shot 3/4" or a...

Totally agree with you that there is a point the barrel needs to go. I also read that Tubbs said to use caution with FF more aggressive...

you used FF type if they were different grit, i didn’t catch that earlier. A Tubb employee warned me against using them in a lapped...

Final Finish pack , think the TMS is throat maintenance system.