Recent content by Eric H

  1. Eric H

    Will we ever see powders again?

    Don't have the load manual for the Woodeigh bullets so will attempt to wing it with some RL17.
  2. Eric H

    Will we ever see powders again?

    I think I'm pretty well stocked as far as powder goes. Couple years ago stocked up on primers and powders along with bulk ammo of 5.56 and blackout. Just got couple pounds of Varget in today with same lot numbers and got too many others to list. Heading out to range tomorrow for ladder...
  3. Eric H

    Has the 30-06 died along with the .308 ???

    Case closed. 30.06 not dead.
  4. Eric H

    Has the 30-06 died along with the .308 ???

    A final question; what will the 30.06 NOT bring down?
  5. Eric H

    Has the 30-06 died along with the .308 ???

    Currently working up a load with Berger 155 over 50gr RL15. Down to 1MOA at 100yds but have to head back out to tweak. Currently .140 off L/G. This rifle was my first. Purchased used in 83.
  6. Eric H

    New 6.5X284

    Went out yesterday and fired the 6.5x284 for the first time just to sight in the scope and wow. Minimum recoil with the brake and I could shoot all day with this thing. Will load for ladder test at 200yds and hopefully all goes well.
  7. Eric H

    SOLD/EXPIRED ATHLON ARGOS BTR GEN2 10-40X56

    NIB SFP MOA Reticle. More than what I need. $415
  8. Eric H

    New 6.5X284

    Which bullet you are you using Bill?
  9. Eric H

    New 6.5X284

    Wow, so much data it's hard to find where to start. Got the H1000, H4831 and Sc, 22/ 23/26 along with 6lbs of H4350.
  10. Eric H

    New 6.5X284

    I do have a .291, 292 and .293. One of these should work. Will know when I get my brass.
  11. Eric H

    New 6.5X284

    Are you saying I may have to turn the necks?
  12. Eric H

    New 6.5X284

    Thanks
  13. Eric H

    New 6.5X284

    Just ordered the LAPUAs. I'm seeing that everyone likes them.
  14. Eric H

    New 6.5X284

    Time to go have some fun.
  15. Eric H

    New 6.5X284

    Thank you all for the advice. Neck in chamber is .299 and will use bushing die to bring brass necks down to .293. My loaded neck diameter should be .296 afterwards.

Trending threads

Top