hello fellow newbie reloader r u sure they r crimped or r seeing the canulure line on the bullet. havent figured out some bullets have the canulure some dont .maybe someone can chime in is there a advantage or not 2 have it.always thought that was a inspection line 4 factory ammo thanks jeff:)
thanks all:
contacted nosler about 55 grain shots in 243 cal there oal was stated by them at 2.450 which they infomored me was below SAMMI .But suggested this length because off short lenght . thats all i got with reasearch thanks all ..will play with it glad got noselers input were oal was so...
thanks
lots of info looks like might want 2 set them out farther got 20 loaded at 2.540 will set 5 out at differnt lenghts 2 suggested.Is there a min col on these bullets
thanks again jeff
Hello all got a new rcbs trim mate prep station. all works fine except the outside deburring tool.screwed it in and out dosent seem 2 cut more work than the old do it by hand tool. just curiours if me or orthers ran into same problem..
hello, was just checking some data that was sent from berger 95 grain vld on h4350 38.5 min and 42.4 max with 92.7 fill ratio.loaded up some imr 4831 at 41 grains wheather turns let u know if the shoot.was just curiours if my data was right on h4350 as far as book starting data goes.thanks jeff