Recent content by Brad615

Wow, them some nice lookin set up's guys! I ended up going with 34% Olive, 33% golden brown & 33% med tan. Lookin fwd to seeing it.

Wow Magnum those are some bad as$ lookin set ups! Thank you!

Wow beautiful looking stocks guys! Thanks for your help!

Hey all, Looking for some help & advice on a stock color. What color/color's would look best with a burnt bronze rifle action/barrel? If anyone has pix they can share that would be great. I'm looking to build a stock in the near future, thank you for your help. Brad

They will be hand loads & I'm currently running .5 to 1 grain under max per berger bullets reload manual. Thank you.

Hello All, Looking for any info/experience you may have with berger bullets 30 cal 180 elite vs 168 vld velocities out of a 26' barrel? Has anyone ran these through a chrony, & if so what were your velocity results? I've read on several forums & in manuals that there putting out very similar...

Yes they do now. On both of my xbolts I did have to make a very minor tweek to the inside of the stock. I had to shave/sand down a very little bit the inside of the stock where it comes into contact to with the right side of the trigger area. Very easy & took 5 mins. If this is something your...

Thank you.

I'm going to try to back off the die as you stated & hope that solves my issue. Thank you.

I'm confused myself :-) Using hornady's headspace gauge kit I measured a fired piece of brass which measured 1.7385 using a mititoyo caliper. I then proceeded to size a cleaned piece of brass using reddings competiton shell holder starting with #4 which was giving me 1.7335. I then begin to use...

Thank you for the reply. The brass I'm working with was cycled 4-5 times (FL) I'm going to shoot them again as I already loaded up more & when I re-size them again I will do what you suggested. Thanks again

Thank you

Hello, I'm having an issue with shoulder bump/adjusting my headspace & hoping somebody can help. I use redding competition dies (FL sizing die & micrometer seating die) with redding competition shell holders & RCBS shell holder. So I resized my brass & noticed my shoulder bump was not adjusting...

Thank you.

Thank you.