Recent content by Aggie1999

PM sent.

PM inbound.

Well, I guess I can take this as a good news/bad news story. Good news: I'm not just missing a simple step in making that trimmer work better. Bad news: looks like I need to invest in a new tool. Thanks for all of the suggestions.

I got this trimmer from my uncle's estate when I started reloading several years ago. I keep struggling with keeping finished trim lengths within 0.005" of each other. I think it is related to the fact the the case is pulled away from the cutter as the collet is tightened. I've tried to tighten...

I hate to somewhat change the focus, but what case trimmers will hold a tight tolerance for less than $200? I have an old original RCBS rotary trimmer and struggle with consistency. I think it has to do with tightening the case in the collet and the collet moving away from the cutter as you...

I'll take this. PM inbound.

This. I have this problem with 30-06. I have 2 shell holders. I doesn't seat flush, the other seats properly. Never can remember which one to use, so I just expect to have to swap them out. I really need to mark them.

I've had problems like this with new brass before as well. Everything smoothed right out after first firing. Might give it a go with fired brass and see what happens.

Veteran just posted that Powder Valley has H4895 in stock.

See this. I've used the 125 gr and they are pretty light recoil.

I'll take this. PM inbound.

But is anything NOT good at a tailgate?!? 🤣🤣

What would he take for the 3 boxes of 30 cal 165 gr Hornady Interlocks, shipped? Thanks.

I'll take it. Sending a PM now.

Sounds like I wasn't too far off the mark. I do like the idea of clear totes holding the bags of one caliber. I may have to do that. Thanks!