Picked up my new 6mm-06 today.

MOJO67

Well-Known Member
Joined
May 20, 2013
Messages
159
Location
Texas
Well, finally decided to drink the 6mm/243 Kool Aid. I've never owned a 6mm/.243 anything, so I had to see what all the hype was about and built a 6mm-06. :)

I had a Rem 700, 25-06 that hasn't seen much use lately, so decided to cannibalize the action and build a 6mm-06. Looked long and hard at the 240 Weatherby and 6-284, but decided on the 6-06 since I already had a lots of 25-06 brass and knew it would feed perfectly out of the existing magazine.Can't wait to put some rounds down range. I have 105 Amaxes and VLD's ready to rock.

Specs:

Remington 700 Action
Brux 8 Twist, 26 inch, Rem Sporter Contour
Chamber cut for long bullets
Bell and Carlson Medalist
Zeiss Conquest 4.5-14X44




Specs:

Remington 700 Action
Brux 8 Twist, 26 inch, Rem Sporter Contour
Chamber cut for long bullets
Bell and Carlson Medalist
Zeiss Conquest 4.5-14X44
 
Well, finally decided to drink the 6mm/243 Kool Aid. I've never owned a 6mm/.243 anything, so I had to see what all the hype was about and built a 6mm-06. :)

I had a Rem 700, 25-06 that hasn't seen much use lately, so decided to cannibalize the action and build a 6mm-06. Looked long and hard at the 240 Weatherby and 6-284, but decided on the 6-06 since I already had a lots of 25-06 brass and knew it would feed perfectly out of the existing magazine.Can't wait to put some rounds down range. I have 105 Amaxes and VLD's ready to rock.

Specs:

Remington 700 Action
Brux 8 Twist, 26 inch, Rem Sporter Contour
Chamber cut for long bullets
Bell and Carlson Medalist
Zeiss Conquest 4.5-14X44




Specs:

Remington 700 Action
Brux 8 Twist, 26 inch, Rem Sporter Contour
Chamber cut for long bullets
Bell and Carlson Medalist
Zeiss Conquest 4.5-14X44
nice .did u go with 1-10 twist I like the heavier pills in 6mm talk about a nice pronghorn and deer rifle
 
Schweet! Keep us informed on how she does.


Remington 700 Action
Brux 8 Twist, 26 inch, Rem Sporter Contour
Chamber cut for long bullets
Bell and Carlson Medalist
Zeiss Conquest 4.5-14X44
 
MOJO67
I too recently purchased a 6mm-06. It's a custom ER Shaw stainless 26" fluted with 1:8 twist. I am shooting SMK 95gr. I absolutely love this cal!
 
MOJO67
I too recently purchased a 6mm-06. It's a custom ER Shaw stainless 26" fluted with 1:8 twist. I am shooting SMK 95gr. I absolutely love this cal!

270,

What powder are you using for the SMK 95? Also, what velocity?

Have you shot anything heavier than the 95's?


MOJO
 
MOJO
I'm using IMR 4831
Velocity of 3375
Shoots 1 ragged hole at 200 yrds. I know I'm at the low end of starting load but for me accuracy means more than speed. I'm going to a buddy's house tomorrow to work out a 1000 yrd chart.
 
Warning! This thread is more than 11 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top