SOLD/EXPIRED TRE Custom Weatherby Mark V 338 Excalibur Bell Carlson Near Brux Timney

[Autorotate]

$3200 for the rifle, bore guide, and dies, shipped insured in a hard plastic case inside a cardboard rifle box.

Built by Master Gunsmith TRE Custom from South Texas

Weatherby Mark V 9 lug Stainless Steel Action
Brux Heavy Palma (shank extended 1/2") 31.25" finish
Holland QD Radial Muzzle Brake
Bell Carlson Weatherby TRR stock
Timeny Trigger adjusted to 1#
Weatherby Mag Drop Box +1 Capacity Kit (Bottom metal)
Near Mfg 30 MOA Base (devcon bedded)

400 rounds through the gun using 300 grainers and Retumbo and H50BMG. Rate of fire never exceeded 15 rounds an hour.

Low 3100s to high 3090 is what I saw with the 300 grainers and the above two powders. It shoots as straight as I can hold it. For me that's a 1/2 MOA at 200 yds during load development on paper, and 1 MOA first round cold bore hits at 1K+ on steel.

It weighs right under 14 lbs with an optic, rings, or bipod.

It will come with 40 pieces of A-Square 338 Excalibur brass, and 25 pieces of Jamison 338 Excalibur brass.

Redding Custom shop Type S FL sizer with nk bushing capability, and a Redding Comp Series Seater that had the sliding sleeve reamed with the finish reamer.

Lucas bore guide.

I have two finish reamers (one Manson, one PTG), both are removable pilot types, that are available as well. The price above doesn't include the reamers.

PLEASE USE EMAIL LINK AT THE BOTTOM OF THIS POST FOR FURTHER INFO

 

[Autorotate]

FYI-The 338 Excalibur is the largest capacity SAAMI case to fit on a .580 bolt face. My accuracy load was 122.5 grains of H50BMG for the 300 SMK at 3090 to 3105 fps.

My fired cases hold just under 140 grains of water with a fired primer seated in backwards.

Left to right...

338 Norma, 338 Lapua, 300 RUM, 338-378 Wby, and then the 338 Excalibur.

 

[Autorotate]

$2350 shipped for the rifle, Near base, and Lucas bore guide

 

[Toddmonty]

Would you trade for Leica Spotting scope??

I also have tripod I'd throw in!!!!!!

Let me know!!!

Todd

 

[Autorotate]

I'm sorry Todd....I'm all good on spotters at the moment. Thank you for the interest.

gun)

 

[Autorotate]

$2350 shipped for the rifle, Near base, and Lucas bore guide. gun)

 

[Autorotate]

$2250 shipped for the rifle, Near base, and Lucas bore guide.

 

[Autorotate]

$2200 shipped for the rifle, Near base, and Lucas bore guide.gun)

 

[Autorotate]

$2100 shipped for the rifle, Near base, and Lucas bore guide.gun)

PLEASE use the email link below if intersted.

Thanks for looking. gun)

 

[Timmyatneb]

2100$ ?

 

[Autorotate]

$2100 shipped for the rifle, Near base, and Lucas bore guide.gun)

PLEASE use the email link below if intersted.

Thanks for looking. gun)

Dies, and a couple different finish reamers, are also available. If you have a specific inquiry, the best way to communicate with me is by clicking on the email link in my signature block below. That will be the quickest way, and get you the best deal

PM is hard to keep up with.

My only motivation to sell, is to thin my herd down, and dedicate my efforts to fewer rifles. This rifle is hard for me to sell...as it's such a performer!

I'll end up keeping one of the three that I've got posted....so the first two to sell will tell me which on I'm keeping.

Thanks for the interest!

 

[Autorotate]

$2000 shipped for the rifle, Near base, and Lucas bore guide.gun)

PLEASE use the email link below if intersted.

Thanks for looking. gun)

 

[Wy Will]

Beautiful rifle!

 

[Autorotate]

Beautiful rifle!

Thank you. Don't like to sell any of them!