264 mag

dud

Well-Known Member
Joined
Feb 14, 2010
Messages
86
currently using h-870 in 264 mag but my supply is low and finding anymore around here aint happening.what else works good for you with 140 gr bullet?26 inch barrel model 70
 
Dud, they haven't made H870 in over a decade so its no wonder you can't find any of it! I have used H1000 in 264Mag with good results but I think about any of the really slow powders might give decent results, though you never know until you try it. I have never cared for my results with the Alliant rifle powders but many handloaders swear by them. I think Accurate Arms stopped producing the AA8700, at least that is what I think I read recently. That may have been a good propellant for the 264.
 
a decade, when i got last 5 pounds 2 years ago i did not know that maybe i should have taken the last 5 he had.i will try the 1000.my doings with the reloader powders seems to be up and down like yours.
 
a decade, when i got last 5 pounds 2 years ago i did not know that maybe i should have taken the last 5 he had.i will try the 1000.my doings with the reloader powders seems to be up and down like yours.
I would look at like or closer burn rates at the link/table below and chose a specific powder and load up with already achieved data such as bullet, primers, COAL and head to the range!

Burn Rate

109 IMR, Co IMR 7828
110 Vihtavouri N170
111 Hodgdon H1000
112 Hodgdon RETUMBO
113 Vihtavouri N570
114 Accurate Arms 8700
115 Hodgdon H870
116 Vihtavouri 24N41
117 Hodgdon H50BMG
118 Hodgdon US869
119 Vihtavouri 20N29

This was in a email Berger sent me PLEASE START LOW AND WORK UP YOUR OWN LOADS.

264 Winchester Magnum
(COAL - 3.340"; Barrel Length - 26")
Bullet Powder Start Load Approximate Start Velocity Max Load Approximate Max Velocity Fill Ratio
120 Grain H1000 67.5 2995 71.0 3267 96.2%
120 Grain RE-22 61.5 3037 65.0 3204 89.7%
120 Grain WW WXR 62.0 3045 65.2 3197 88.5%
120 Grain IMR7828 SSC 62.0 3062 65.1 3216 88.4%
120 Grain NORMA MRP 62.0 3052 65.5 3219 88.5%
120 Grain Ramshot Magnum 67.0 3034 70.8 3227 92.2%
120 Grain VIHT N560 62.0 3056 65.4 3223 87.4%
120 Grain VIHT N170 68.0 2953 71.8 3134 99.6%
120 Grain RE-25 64.5 3087 67.8 3237 95.1%
130 Grain H1000 63.0 2909 68.0 3154 95.6%
130 Grain RE-22 58.5 2916 61.8 3072 88.5%
130 Grain WW WXR 58.5 2901 61.8 3057 87.1%
130 Grain IMR 7828 SSC 59.0 2940 63.5 3161 89.5%
130 Grain NORMA MRP2 61.0 2848 65.8 3080 95.3%
130 Grain Ramshot Magnum 64.0 2927 67.3 3092 91.0%
130 Grain VIHT N170 65.5 2873 68.8 3030 99.1%
130 Grain H4831 SC 60.0 2905 63.2 3059 88.6%
130 Grain IMR 4350 54.0 2958 56.8 3086 83.1%
130 Grain RE-25 61.5 2970 64.7 3113 94.2%
140 Grain H1000 62.5 2839 67.3 3062 93.8%
140 Grain RE-25 59.5 2826 62.8 2968 90.6%
140 Grain WW WXR 58.0 2827 61.0 2962 85.2%
140 Grain IMR 7828 SSC 58.5 2866 61.7 3017 86.1%
140 Grain NORMA MRP2 61.5 2829 65.0 2990 93.2%
140 Grain Ramshot Magnum 63.0 2835 66.3 2992 88.8%
140 Grain VIHT N170 64.5 2783 67.2 2906 95.8%
140 Grain H4831 SC 59.5 2831 62.0 2946 86.1%
140 Grain IMR 4350 53.5 2871 55.8 2971 80.9%
140 Grain US869 71.0 2822 75.0 3013 104.1%
140 Grain RETUMBO 65.0 2871 68.5 3026 97.7%
140 Grain H870 68.5 2847 72.0 3015 100.0%
140 Grain VIHT N570 65.5 2855 69.3 3043 94.3%
140 Grain RE 22 57.5 2818 60.5 2954 85.8%
 
Last edited:
My 264 win mag loves Retumbo. I have a 27 3/4 barrel and get 3350 fps and ragged hole groups at 100 and under 2" at 300 with 130 Nosler Accubonds with 66.5 grs and the bullet 10 thousands off the lands. I took 4 deer with this combo this past season from 98 to 275 yards and it did a number on each. Bang Flop.
 
My rifle likes Retumbo also, 68 grains under a 140 gr Berger, WW case, 215M primer, gives me 3166 fps in a 26 inch barrell.
 
I have a 264 in rem 700 BDL it does not care for the retumbo but loves H4831SC and H1000.

What I like about the extreme powders is that they do not change have very big variances when going from one extreme to the other or at least in my Rem 700.
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top