338 Rum to the Max !

Rum Man

Well-Known Member
Joined
Nov 2, 2017
Messages
2,579
Location
Michigan
I'm looking for info and or experiences with taking the 338 Rum to its max ability.

Should I get a throat reamer ?
Should I sent the barrel out to Shawn Carlock to get the +P treatment?
Is there a special reamer out there ?
It's a standard cut chamber Rum right now.

Looking for any advice or info !

I have Adg brass, lots of different powders to test /try and going to use the 300 gr bergers as my bullet of choice .

This set up will be my hunting Rig to way out there ! Maybe 1500 yards ??

Defiance Tenacity, prefit Proof 1/9.4 twist 26" barrel . This Rifle will have 125 min. Of Elevation available when it's done!
I dont care about oal !
This will be Single fed !
I already know about the 338 Edge is a touch better so we can let that go for now.

Thanks for all your help !

Rum Man
 
I'm looking for info and or experiences with taking the 338 Rum to its max ability.

Should I get a throat reamer ?
Should I sent the barrel out to Shawn Carlock to get the +P treatment?
Is there a special reamer out there ?
It's a standard cut chamber Rum right now.

Looking for any advice or info !

I have Adg brass, lots of different powders to test /try and going to use the 300 gr bergers as my bullet of choice .

This set up will be my hunting Rig to way out there ! Maybe 1500 yards ??

Defiance Tenacity, prefit Proof 1/9.4 twist 26" barrel . This Rifle will have 125 min. Of Elevation available when it's done!
I dont care about oal !
This will be Single fed !
I already know about the 338 Edge is a touch better so we can let that go for now.

Thanks for all your help !

Rum Man
I think you will benefit from +P throating esp. when your case capacity is not maxed out.
 
Thanks !
The +P.is heavy on my mind . I have a close friend that had Shawn build him a 338 Edge and is getting Amazing results with Nv570 and 300 gr Otm's . 300 ft.per.sec faster then any Edge I have had.

Rum Man
 
I run 300eh with N570 in my throated rum. 2810 is 1.5gr below psi. Its a 28" proof 9.4tw made several years back. Its on a Terminus helios that was cut for 4" mag box. A bat action with 1-1/8 tenon may get you to the next node, but it would be HOT. RL33 is another good powder with the 300gr bullets.
 
Thanks !
Rl-33 is a powder I haven't tryed yet . I did end up with 2884 ft.per.sec in a 30" Carbon barreled 338 Rum with H-1000.
This one is a 1/9.4 26" Proof . If I can get it close to 3000 ft.per.sec or more I will be happy !
I'm going to talk to Shawn about his +p and then make a plan so far.
Thanks !

Rum Man
 
Why not just chamber it in the 338 edge? 90 thousandths of additional powder column is a great start.
LRT has the fastest velocities for a 300 berger in my edge....over 100 grains. It's pretty accurate too, but fairly dirty.
I use N570 for the 262 gr hammer and
H1000 for the 300 berger
 
Why not just chamber it in the 338 edge? 90 thousandths of additional powder column is a great start.
LRT has the fastest velocities for a 300 berger in my edge....over 100 grains. It's pretty accurate too, but fairly dirty.
I use N570 for the 262 gr hammer and
H1000 for the 300 berger
I have several 338 Edge Rifles already !
Been out to 3027 yards with one of them .

Rum Man
 
What exactly does the +P treatment consist of?
My 338 RUM is on a 700 action with a #5 27" Krieger. With Nosler brass, 250 AB and Retumbo I'm get 3120 fps and 2.0" groups at 800 yds.
Tell me more...

JD338
Its explained on his Site in depth .
Rum Man
 
I put these two rifles together years back .
338 Rum 30" Benchmark carbon 1/10 twist. Both built on Remington action's.
338 Edge 30" Proof Carbon .
Did load work with h'1000 and 300 gr bergers. No other powder at the time .

They ended up at 2884 and 2883 ft.per.sec. So I proved to my self that the 338's are so close to each other that the Rum would be a great choice if your trying to go the cheapest route , if you had a 300 Rum you could just resize the brass to the Edge . Dies are alot different in price also. Rum being alot cheaper and less steps to reload .

I'm sure I will always have a few of both of them around . Just my favorites I guess.

Rum Man
 

Attachments

  • 20190203_133841.jpg
    20190203_133841.jpg
    1.5 MB · Views: 58
Thanks !
The +P.is heavy on my mind . I have a close friend that had Shawn build him a 338 Edge and is getting Amazing results with Nv570 and 300 gr Otm's . 300 ft.per.sec faster then any Edge I have had.

Rum Man
The +p treatment eats out enough throat that I wouldn't do it period. If you want your throat half shot out, go shoot it out. rl33 is also a bit slow burning and bulky for a 338rum. I'm at a full case with my 300rums and 225's using rl33. I'd think a slow burning rather dense powder like lrt might be the ticket here. The new sta-ball hd? powder that's supposed to be ball/ retumbo might also be useful to you.
 
Top