I'm curious as well
Absolute Hammer load data
- Thread starter RockyMtnMT
- Start date
Help Support Long Range Hunting Forum
For reference sake could you mark on a pic of a bullet of what the last PDR band is?
Thanks
Are you crimping ?
I haven't yet, but plan on trying some
Here is why you want to seat and cri in the groove
That is where I typically seat, and these ones maybe even a touch higher with the short magazines for cartridge (Tikka for the 280, model 7 for the 7-08). All crimped with Lee FCD, with similar crimp to what I have done with HH and SH I have have loaded with great success. Varied the crimp with minimal change. Its a head scratcher- I'm getting great consistency of velocity, but accuracy hasn't followed. The 155 slowed down to 2980 shot very well- those two groups below were the six I shot to see if a little extra crunch bothered it at all (One was 58.0, one 58.3 RL23). ES for both charge weights combined was 11. That load will do all I really need it to do, but is probably down to 1800 inside 600 yards. The 7-08 is probably accurate enough to be the 400 and in gun it is meant to be, But it would be nice to get it a little tighter. Hopefully it will like the 119 or 120 more.
Attachments
Bud I don't know what your looking for but I'll take that all day long
Oh that one is great- it was all the other faster powders (as suggested) that wouldn't group. This was the first sub inch group out of a whole bunch of these + the 140s. Didn't tighten up until I went to traditional for bullet weight powder. I'll shoot some slower powder with the 140s as well and see if they come around. Might try the same with the 130s in the other rifle- maybe H4350 burn rate instead of Varget.
I just never found the other Hammers to be picky at all. Speeds varied, but whatever I put under them seems to put them in about the same spot. Low ES does seem to be effortless with the AH so far.
Well after lurking for years, the community support for the AHs got me to join and share results. 1st Post.
Savage 11 Action
260 Rem 123 AH
26" 1:8 barrel
Starline Brass
Federal 210s
COAL 2.8185
H4895
load Vel
38.2 2900
38.4 2903
38.6 2925
38.8 2943
39 2955
39.2 2973
39.4 2978
39.6 2987
39.8 3009
40 3030
No pressure signs at all so I will load up to 41gr in the next few weeks.
Savage 11 Action
260 Rem 123 AH
26" 1:8 barrel
Starline Brass
Federal 210s
COAL 2.8185
H4895
load Vel
38.2 2900
38.4 2903
38.6 2925
38.8 2943
39 2955
39.2 2973
39.4 2978
39.6 2987
39.8 3009
40 3030
No pressure signs at all so I will load up to 41gr in the next few weeks.
Brother Buckwheat
Well-Known Member
- Joined
- Jan 9, 2014
- Messages
- 57
ButterBean,
Let me get this correct. You are crimping above the groove, just below the ogive?
My AH should be here this week or next I hope. Will be .308 dia., in 300 WM- 151 and 178 to play with, using 6.5 StaBall. Lee FCD. Rem 700.
Crimp in the groove
