Forming 243 brass

You could also just sell them or trade them for some 243 and probably come out ahead, 260 is by far the most coveted in that "family" of brass cases.

Dean
 
Last edited:
When I do things like this I anneal the brass first, remove stem from 243 sizing die run 260 brass thru die trim to length then reinstall stem and resize and load. In some instances you may need to turn the necks but not always.
 
When I do things like this I anneal the brass first, remove stem from 243 sizing die run 260 brass thru die trim to length then reinstall stem and resize and load. In some instances you may need to turn the necks but not always.
Yes that works like a charm I have done that many times and I have not had to turn the necks, if I had to turn the necks I would not do it and find something else I am to lazy to turn necks.

Dean
 
Warning! This thread is more than 4 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top