Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Yet another DIY bedding question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jarnold37" data-source="post: 1889552" data-attributes="member: 29241"><p>One more reply and then I will quit before I make someone mad. With an aluminum chasis or block I rough up the aluminum and bed right on the aluminum block-no need for pillars, that will basically hold the action up off the aluminum block. Which leaves most of the support on the two pillars when you tighten the action screws. The pillars wont shrink but the compound will, even if very minutely, cancelling the support of the aluminum block and the bedding.</p></blockquote><p></p>
[QUOTE="jarnold37, post: 1889552, member: 29241"] One more reply and then I will quit before I make someone mad. With an aluminum chasis or block I rough up the aluminum and bed right on the aluminum block-no need for pillars, that will basically hold the action up off the aluminum block. Which leaves most of the support on the two pillars when you tighten the action screws. The pillars wont shrink but the compound will, even if very minutely, cancelling the support of the aluminum block and the bedding. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Yet another DIY bedding question
Top